Benachrichtigungen
Alles löschen
Filament Sensor Stuck on "1"
Hi.
I've been through the FS troubleshooting page and read through threads and can't seem to find my exact problem. The only thing that sends the FS back to "0" is to unplug it from the wire. Dislodging it from it's seat still leaves it on "1". If I switch it with another FS it still says "1" while unseated. What could cause a unseated Filament Sensor to stay stuck on "1"?
Thanks!
Veröffentlicht : 20/11/2024 9:27 pm
RE: Filament Sensor Stuck on "1"
Are the5 volts and 0 volts (gnd) wire, connected? test at the filament sensor end sometimes one goes open circuit giving a stuck indication
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
Veröffentlicht : 20/11/2024 10:59 pm