1st layer speed setting in Prusa slicer

Dernier message

RSS

philflo

(@philflo)

Eminent Member

1st layer speed setting in Prusa slicer

Can I adjust the speed for the first layer in the Prusa slicer?

Thanks

Publié : 06/03/2020 8:06 pm

bobstro

(@bobstro)

Illustrious Member

RE: 1st layer speed setting in Prusa slicer

Yes

My notes and disclaimers on 3D printing

and miscellaneous other tech projects
He is intelligent, but not experienced. His pattern indicates two dimensional thinking. -- Spock in Star Trek: The Wrath of Khan

Publié : 06/03/2020 8:30 pm

philflo

(@philflo)

Eminent Member

Topic starter answered:

RE: 1st layer speed setting in Prusa slicer

Thank you, Could you tell me where the setting is under?

Publié : 06/03/2020 8:35 pm

bobstro

(@bobstro)

Illustrious Member

RE: 1st layer speed setting in Prusa slicer

Try Print Settings->Speed. Can't verify now, but fairly certain that's it

My notes and disclaimers on 3D printing

and miscellaneous other tech projects
He is intelligent, but not experienced. His pattern indicates two dimensional thinking. -- Spock in Star Trek: The Wrath of Khan

Publié : 07/03/2020 12:39 am

Statistiques du forum

559 Forums

62.9 K Sujets

442.9 K Messages

19 En-ligne

67.6 K Membres

Le dernier des messages: Random pauses in prints since upgrading to 6.1.3-7898 Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé