Notifiche
Cancella tutti

Rectilinear infill  

  RSS
LPS Tech Guy
(@lps-tech-guy)
Utenti
Rectilinear infill

Here's a crazy question:  Is there a way to control the direction on Rectilinear infill on the top layer?  Can I make it go horizontal across my object? What about vertical?  How does Prusa slicer decide what direction to print this infill?  

Postato : 20/05/2024 4:05 pm
JoanTabb
(@joantabb)
Veteran Member Moderator
RE: Rectilinear infill

turn the model 45 degrees, Lol... 

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Postato : 20/05/2024 8:40 pm
LPS Tech Guy
(@lps-tech-guy)
Utenti
Topic starter answered:
RE: Rectilinear infill

Thanks.....I didn't see that.  

Postato : 20/05/2024 8:50 pm
JoanTabb
(@joantabb)
Veteran Member Moderator
RE: Rectilinear infill

🙂 probably easier than turning the model!

regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Postato : 20/05/2024 8:52 pm
Condividi: