Rectilinear infill
Here's a crazy question: Is there a way to control the direction on Rectilinear infill on the top layer? Can I make it go horizontal across my object? What about vertical? How does Prusa slicer decide what direction to print this infill?
RE: Rectilinear infill
turn the model 45 degrees, Lol...
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK
RE: Rectilinear infill
Thanks.....I didn't see that.
RE: Rectilinear infill
🙂 probably easier than turning the model!
regards Joan
I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK