Firmware 3.5.0-RC1 for Original Prusa i3 MK3

Page 2 / 2 Précédent

Dernier message

RSS

Tim

(@tim-12)

Active Member

Re: Firmware 3.5.0-RC1 for Original Prusa i3 MK3

Hey Chris,

I also was getting "Access is denied" when trying to update the firmware. In one of the tabs, in the Properties for the COM port for Original Prusa i3 MK3, there was a message that the device wasn't completely set up. (That wasn't the exact message, just the jest of it,) So, on the drivers tab, I clicked Update Drivers. It wanted a reboot of my machine. After it booted up, I was able to flash with the latest firmware.

So, try updating the drivers by clicking that button and letting it search the internet for a newer driver.
Good luck.

Publié : 12/01/2019 4:38 am

Page 2 / 2 Précédent

Statistiques du forum

559 Forums

62.9 K Sujets

442.7 K Messages

18 En-ligne

67.5 K Membres

Le dernier des messages: Would You Guys Buy the 5Head XL Again? Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé