Benachrichtigungen
Alles löschen

[Gelöst] Weird finish on first layer  

  RSS
Toochi
(@toochi)
New Member
Weird finish on first layer

I am new to 3D printing and assembled the MK3S+ from a kit. I started to notice that there where some weird surface layers being produced, especially near the centre of the bed.

What would be the cause of the weird finishes on this first layer? Also why is it that the printing done in the corners of the bed do not seem to be affected?

I assume it might have something to do with the bed being higher or lower in the centre than the rest of the bed but I’m not sure. 

Thanks 

Best Answer by Robin:

You are way to high with your first layer. See: https://help.prusa3d.com/article/first-layer-calibration-i3_112364

 

Veröffentlicht : 31/01/2023 4:07 pm
Robin
(@robin)
Prominent Member
RE: Weird finish on first layer

You are way to high with your first layer. See: https://help.prusa3d.com/article/first-layer-calibration-i3_112364

 

If at first you don't succeed, skydiving is not for you.

Veröffentlicht : 01/02/2023 1:05 pm
Toochi
(@toochi)
New Member
Themenstarter answered:
RE: Weird finish on first layer

Thanks heaps! 

Veröffentlicht : 02/02/2023 6:04 am
Teilen: