Strange stringing effect around print
Hi everyone,
I'm totally new to 3D printing, and I received my preassembled Prusa i3 MK3S in the mail yesterday.
While testing it, I noticed there's an odd stringing effect around the bottom of the prints. Attached is a photo of this when I tried to print the bed level test, and also when I tried to print the Prusa logo (after about 10 minutes it separated from the steel sheet, and I think the two issues are related).
If anyone knows what's going on, I'd be really thankful if you helped a newbie out!
RE: Strange stringing effect around print
Your first layer if to high.
And clean bed with dish soap .
Both settings are to get filament stick better.
The first layer should be pressed down a little bit.
search on forum on - first layer calibration
RE: Strange stringing effect around print
@peter-m26
Lowering the extruder using Live-Z fixed the problem.
Thanks!