Notifications
Clear all

Marking the assembly manual for disabled folk  

  RSS
ibak
 ibak
(@ibak)
New Member
Marking the assembly manual for disabled folk

Howdy Prusa People,

I was wondering if someone at Prusa would be able to update the assembly instructions with numbers to go along with each of the colored dots? I am colorblind and find it hard to match the colored arrows to the steps listed to the side. A set of numbers (symbols, letters, etc) on each step that matched the pictured step would be nice so I don't have to guess. You could also use patterned colors (eg. crosshatch. Maybe infill patterns, haha).

Posted : 12/11/2020 11:02 am
Neophyl
(@neophyl)
Illustrious Member
RE: Marking the assembly manual for disabled folk

Unfortunately this is mainly a user to user forum.  You will have to hope one of the prusa staff sees your post and can communicate it for you.

An alternative would be to make a comment on the Manual website with the request in there.  That might get spotted quicker.  Or possibly email support with the suggestion.

Posted : 12/11/2020 12:08 pm
--
 --
(@)
Illustrious Member
RE: Marking the assembly manual for disabled folk

Each page in the [on-line] assembly manual has a comments section, too. Though too little too late for us who are not among the ranks of the color-normal people.  Was that a hint of peach or persimmon? Maybe a touch of jasmine or lavender, too?

 

This post was modified 4 years ago by --
Posted : 14/11/2020 12:11 am
Share: