Notifications
Clear all

bumps  

  RSS
armando.c2
(@armando-c2)
New Member
bumps

can anyone help me out and tell me how to correct this issue that happened after i upgraded to the new firmware.

I have adjusted retraction to 1mm, retract on layer change is enabled as well as wipe while retracting (slic3r PE).

Opublikowany : 19/12/2018 10:58 pm
thrawn86
(@thrawn86)
Honorable Member
Re: bumps

normal. use the align seam option if you want to try and hide them better.

tuning your K value can also help.

Opublikowany : 20/12/2018 12:01 am
francisco.b5
(@francisco-b5)
Active Member
Re: bumps

I have also the same problem.
Do you had checked if downgrading firmware will help?
Which version of the firmware do you have?

Opublikowany : 09/01/2019 5:14 pm
rob.l6
(@rob-l6)
Honorable Member
Re: bumps

It is the layer change seam. It's normal. Check your model in Slic3r, it will also show their location so you can try to make them less prominent.

Opublikowany : 10/01/2019 3:30 am
Share: