English
Forums
English forum
Original Prusa i3 MK2/S
Others (Archive)
Y-axis endstop not working
 
Notifications
Clear all

Y-axis endstop not working  

    Last Post
  RSS
Carlos Echenique
 Carlos Echeniq...
(@carlos-echenique)
Active Member
Y-axis endstop not working

The Y-axis endstaop has stopped working on my one month old Mk2s. If I home the bed, it starts chattering when the endstop should kick in. I have already done the following:

  • Pushed the bed back and listend to see if it engages the endstop with a click,

  • Pulled the endstop wire from the RamBo board and tested continuity. It works.

  • Flashed the firmware. No change.

  • Sent an email to [email protected] detailing all of the above.

    • Any suggestions?

    Carlos Echenique
    ce.photography
    Prusa i3 MK2s + Prusa XL Two Head (Coming Soonâ„¢)

    Posted : 20/06/2017 4:04 am
    jack.f3
     jack.f3
    (@jack-f3)
    Active Member
    Re: Y-axis endstop not working

    I had the same issue.
    On my printer the printed piece that holds the button that engages the endstop broke.

    I don't know why it broke, but you can download the files from the main prusa website and reprint the broken part.

    Posted : 20/06/2017 6:24 am
    Carlos Echenique
     Carlos Echeniq...
    (@carlos-echenique)
    Active Member
    Topic starter answered:
    Re: Y-axis endstop not working

    I checked that Jack and mine is fine. In fact, I pressed the switch down with my finger and ran an M119 command and it reported the switch as open.

    Carlos Echenique
    ce.photography
    Prusa i3 MK2s + Prusa XL Two Head (Coming Soonâ„¢)

    Posted : 20/06/2017 6:53 am
      All forum topics
      Previous Topic
    Next Topic  
    Share: