X and Z have offset while printing

Ultimi post

RSS

sravan.s

(@sravan-s)

New Member

X and Z have offset while printing

Dear all,

I recently bought a MK2 original. I tried printing the calibration cube and found that rather than 20mm , the X was having 19.7mm and Z is 20.3mm.
I really dont know how to calibrate the same to get 20mm accurate or atleast near to that. Please help me on this

Postato : 12/01/2018 11:34 am

Statistiche Forum

566 Forum

63.2 K Discussioni

444.3 K Post

22 Online

68.1 K Utenti

Post recenti: M112 error when sending gcode from Octoprint to MK3.5S but prints fine from USB stick Ultimo utente registrato: etiennep Post recenti Post da leggere Etichette

Icone forum: Il forum non contiene post non letti Il forum contiene post non letti

Icone discussione: Nessuna Risposta Con risposte Attivo Hot In evidenza Disapprovato Risolto Privato Chiuso