X and Z have offset while printing

Dernier message

RSS

sravan.s

(@sravan-s)

New Member

X and Z have offset while printing

Dear all,

I recently bought a MK2 original. I tried printing the calibration cube and found that rather than 20mm , the X was having 19.7mm and Z is 20.3mm.
I really dont know how to calibrate the same to get 20mm accurate or atleast near to that. Please help me on this

Publié : 12/01/2018 11:34 am

Statistiques du forum

559 Forums

63.1 K Sujets

444 K Messages

19 En-ligne

68 K Membres

Le dernier des messages: MK4S Upgrade -> HF Nozzle -> Organic Suports = Fail. Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé