Paper catching on xyz calibration
I got the "bed leveling failed sensor triggered to high" error today so i went to recalibrate. When I did, the paper caught and was dragged a little on calibration point two. I followed the directions and turned the printer off. I tried it again with the same effect. What should I do here? It didn't do this before.
Re: Paper catching on xyz calibration
Lower the probe - just a little bit.
Peter
Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…
Re: Paper catching on xyz calibration
I'll give it a shot. I'm having issues with the pla not sticking and I've got a raft just for that.
Re: Paper catching on xyz calibration
These steps will help with adhesion:
Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss. If you solve your problem, please post the solution…