Paper catching on xyz calibration
 
Notifications
Clear all

Paper catching on xyz calibration  

  RSS
ryan.f15
(@ryan-f15)
Estimable Member
Paper catching on xyz calibration

I got the "bed leveling failed sensor triggered to high" error today so i went to recalibrate. When I did, the paper caught and was dragged a little on calibration point two. I followed the directions and turned the printer off. I tried it again with the same effect. What should I do here? It didn't do this before.

Posted : 04/11/2017 2:52 am
PJR
 PJR
(@pjr)
Antient Member Moderator
Re: Paper catching on xyz calibration

Lower the probe - just a little bit.

Peter

Please note: I do not have any affiliation with Prusa Research. Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage…

Posted : 04/11/2017 10:20 am
ryan.f15
(@ryan-f15)
Estimable Member
Topic starter answered:
Re: Paper catching on xyz calibration

I'll give it a shot. I'm having issues with the pla not sticking and I've got a raft just for that.

Posted : 04/11/2017 8:49 pm
AJS
 AJS
(@ajs)
Noble Member
Re: Paper catching on xyz calibration

These steps will help with adhesion:

http://shop.prusa3d.com/forum/prusa-i3-kit-building-calibrating-first-print-main-f6/-before-you-ask-troubleshooting-video-updated--t472.html#p39190

Any advices given are offered in good faith. It is your responsibility to ensure that by following my advice you do not suffer or cause injury, damage or loss. If you solve your problem, please post the solution…

Posted : 04/11/2017 9:25 pm
Share: