Notifications
Clear all
clogged extruder
i was printing something overnight when i cam in the morning the print was half way done and the end of the filament was hanging loose next to it, i opened the cartridge compartment and this is what i see:
what do i do to unclog it?
Publié : 27/07/2017 7:04 pm
Topic starter
answered:
Re: clogged extruder
this is what i did:
- i warmed up the nozzle for ABS (with PLA being stuck)
- i took the loose end of PLA hanging around and i used it to push the broken end into the heat chamber observing the plastic being pushed out from the nozzle
- then i kept pushing the filament for about 2 inches more to make sure it flows out freely
- now it's all nice and clean and ready for printing again
Publié : 28/07/2017 12:05 am