Avisos
Vaciar todo

SMOOTHER  

  RSS
Retired
(@retired)
Eminent Member
SMOOTHER

Has anyone used a smoother on a Prusa 3MK2S printer?

It is an electronic device that plugs in between your printer computer board and your stepper motors.  

It supposed to make your print surface smooth. 

Harley

Respondido : 25/05/2020 11:29 pm
danielkrah
(@danielkrah)
Eminent Member
RE: SMOOTHER

No, i use a MKS Gen 1.4 board with TMC2100 drivers + https://github.com/cimoalpacino/Prusa-Firmware/tree/MK2S_3.9.0_RAMPS

Should be the better upgrade because you also get Linear advance 1.5 ...

Respondido : 03/06/2020 9:03 pm
cimoalpacino
(@cimoalpacino)
Active Member
RE: SMOOTHER
Posted by: @kelsey-harley

Has anyone used a smoother on a Prusa 3MK2S printer?

It is an electronic device that plugs in between your printer computer board and your stepper motors.  

It supposed to make your print surface smooth. 

Harley

Firstly you need to have your mechanics sorted out. I have A4988 drvers...they are loud, but apart from a small amount of ringing, my prints come out great.
I use Arduino+RAMPS + Prusa fw 3.9.0 that I modified to fit my setup (inverted endstops, pinda V1 and slightly different x/y/z offsets).

Respondido : 09/06/2020 6:50 pm
Compartir: