Clear all

[Closed] Filament not loading well in MMU1  

Active Member
Filament not loading well in MMU1

Loading filament to my i3 MK2s MMU1 sometimes succeeds at once, but often it doesn't reach the end of the tube, some 5-10 cm too short. This can happen in all 4 extruders. If so I have to load a second time: not good for the gears I suggest. The tubes are tested allright.

So: what causes the problem? Is it the firmware - latest alive -, if so how can the loadinglength be changed. Or what is it?

Hope somebody can help...

Thnx in advance, Kees (from the Netherlands)


Posted : 27/11/2019 7:35 pm