Español
Foros
English forum
Original Prusa i3 MK2.5 & MK2.5S
Hardware, firmware and software help
help needed upgrade to mk 2.5s - RAMB010a Board - firmware update succeded... but display does not show anything after power cycle
 
Avisos
Vaciar todo

[Resuelto] help needed upgrade to mk 2.5s - RAMB010a Board - firmware update succeded... but display does not show anything after power cycle  

    Último Mensaje
  RSS
michael.r
 michael.r
(@michael-r)
Eminent Member
help needed upgrade to mk 2.5s - RAMB010a Board - firmware update succeded... but display does not show anything after power cycle

Hi,

tried different firmware updates over prusa slicr 2.1.1 latest fw version 3.8.1 and 3.7.0 same result, the display shows only two rows of "blocks"

please help

Respondido : 21/02/2020 4:33 pm
michael.r
 michael.r
(@michael-r)
Eminent Member
Topic starter answered:
RE: help needed upgrade to mk 2.5s - RAMB010a Board - firmware update succeded... but display does not show anything after power cycle

ok was a RAMBo13a - board not a 10a so wrong firmware

Respondido : 21/02/2020 5:11 pm
Russell
 Russell
(@russell-3)
Active Member
RE: help needed upgrade to mk 2.5s - RAMB010a Board - firmware update succeded... but display does not show anything after power cycle

saved me a bunch of time, i completely forgot there were 2 versions

Respondido : 31/03/2020 4:01 pm
  Todos los debates del foro
  Anterior debate
Siguiente debate  
Compartir: