Deutsch
Foren
English forum
Original Prusa i3 MK2.5 & MK2.5S
Hardware, firmware and software help
help needed upgrade to mk 2.5s - RAMB010a Board - firmware update succeded... but display does not show anything after power cycle
 
Benachrichtigungen
Alles löschen

[Gelöst] help needed upgrade to mk 2.5s - RAMB010a Board - firmware update succeded... but display does not show anything after power cycle  

    Letzter Beitrag
  RSS
michael.r
 michael.r
(@michael-r)
Eminent Member
help needed upgrade to mk 2.5s - RAMB010a Board - firmware update succeded... but display does not show anything after power cycle

Hi,

tried different firmware updates over prusa slicr 2.1.1 latest fw version 3.8.1 and 3.7.0 same result, the display shows only two rows of "blocks"

please help

Veröffentlicht : 21/02/2020 4:33 pm
michael.r
 michael.r
(@michael-r)
Eminent Member
Themenstarter answered:
RE: help needed upgrade to mk 2.5s - RAMB010a Board - firmware update succeded... but display does not show anything after power cycle

ok was a RAMBo13a - board not a 10a so wrong firmware

Veröffentlicht : 21/02/2020 5:11 pm
Russell
 Russell
(@russell-3)
Active Member
RE: help needed upgrade to mk 2.5s - RAMB010a Board - firmware update succeded... but display does not show anything after power cycle

saved me a bunch of time, i completely forgot there were 2 versions

Veröffentlicht : 31/03/2020 4:01 pm
  Alle Forumsthemen
  Vorheriges Thema
Nächstes Thema  
Teilen: