Čeština
Fóra
English forum
Original Prusa i3 MK2.5 & MK2.5S
Hardware, firmware and software help
help needed upgrade to mk 2.5s - RAMB010a Board - firmware update succeded... but display does not show anything after power cycle
 
Notifications
Clear all

[Solved] help needed upgrade to mk 2.5s - RAMB010a Board - firmware update succeded... but display does not show anything after power cycle  

    Poslední Příspěvek
  RSS
michael.r
 michael.r
(@michael-r)
Eminent Member
help needed upgrade to mk 2.5s - RAMB010a Board - firmware update succeded... but display does not show anything after power cycle

Hi,

tried different firmware updates over prusa slicr 2.1.1 latest fw version 3.8.1 and 3.7.0 same result, the display shows only two rows of "blocks"

please help

Napsal : 21/02/2020 4:33 pm
michael.r
 michael.r
(@michael-r)
Eminent Member
Topic starter answered:
RE: help needed upgrade to mk 2.5s - RAMB010a Board - firmware update succeded... but display does not show anything after power cycle

ok was a RAMBo13a - board not a 10a so wrong firmware

Napsal : 21/02/2020 5:11 pm
Russell
 Russell
(@russell-3)
Active Member
RE: help needed upgrade to mk 2.5s - RAMB010a Board - firmware update succeded... but display does not show anything after power cycle

saved me a bunch of time, i completely forgot there were 2 versions

Napsal : 31/03/2020 4:01 pm
  All forum topics
  Previous Topic
Next Topic  
Share: