Lost in a few months

Dernier message

RSS

Thierry09

(@thierry09)

Active Member

Lost in a few months

Hi,

4 months after last printings on Prusa MK4 then I get lost.

I had to update firmware and Prusa Slicer to last versions (FIRMWARE 6.1.3 - PRUSASLICER 2.8) then here are my questions:

- Is there any reason not to find 0.3mm layer presets?

- Is there any reason not to find any preset for MK4 printer without input shaper? I can remember crash detection was not enabled for exemple. Is this still the case?

- Is there any way to retrieve the "old presets" during configuration process if necessary?

Thanks in advance for your help

Thierry

Publié : 08/09/2024 6:13 am

Statistiques du forum

559 Forums

62 K Sujets

438.8 K Messages

18 En-ligne

67.1 K Membres

Le dernier des messages: First TPU Print Notre nouveau membre: Gajowy Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé