Notifications
Clear all

Lost in a few months  

  RSS
Thierry09
(@thierry09)
Active Member
Lost in a few months

Hi,

4 months after last printings on Prusa MK4 then I get lost.

I had to update firmware and Prusa Slicer to last versions (FIRMWARE 6.1.3 - PRUSASLICER 2.8) then here are my questions:

- Is there any reason not to find 0.3mm layer presets?

- Is there any reason not to find any preset for MK4 printer without input shaper? I can remember crash detection was not enabled for exemple. Is this still the case?

- Is there any way to retrieve the "old presets" during configuration process if necessary?

Thanks in advance for your help

Thierry

Napsal : 08/09/2024 6:13 am
Share: