Avisos
Vaciar todo
Lost in a few months
Hi,
4 months after last printings on Prusa MK4 then I get lost.
I had to update firmware and Prusa Slicer to last versions (FIRMWARE 6.1.3 - PRUSASLICER 2.8) then here are my questions:
- Is there any reason not to find 0.3mm layer presets?
- Is there any reason not to find any preset for MK4 printer without input shaper? I can remember crash detection was not enabled for exemple. Is this still the case?
- Is there any way to retrieve the "old presets" during configuration process if necessary?
Thanks in advance for your help
Thierry
Respondido : 08/09/2024 6:13 am