Notifications
Clear all
Clicking 1st layer Revo Mini
Anybody else with clicking and filament stopping extrusion on long, difficult first layers?
All with Revo and no issues: which hot end fan are you using? The small one from E3d or the standard from Prusa?
Publié : 02/10/2023 10:56 am
RE: Clicking 1st layer Revo Mini
I'm running the Revo with the Prusa hotend fans, they works like a charm with the IS firmware and 0.4 mm, but the prints with IS enabled are first layer height dependent, I had some clicking too until recalibrated the first layer offset.
Printing is done on textured bed with PLA and 215ºC/70ºC
Publié : 03/10/2023 9:35 am
Topic starter
answered:
RE: Clicking 1st layer Revo Mini
I did the same now. Reworked the printers to be with the Prusa hot end fan. This solved the issue of clicking. Thanks for your help!
Publié : 19/10/2023 2:15 pm