Prusament ASA printing
I am using a brand new stock Prusa Mini+. I am using PrusaSlicer 2.4.0 and the default PrusaSlicer settings for Prusament ASA. It is a fresh role of ASA straight out of the vacuum packed bag so I don't think it has absorbed any moisture. My DIY enclosure is running at 36C. Printing at .15 Quality, 260C nozzle and 100C bed, fan speed 20% and all the rest of the stock PrusaSlicer settings for ASA. Does anyone have any thoughts on where to start to try and clean up the pitting/voids on my prints?
Joel
RE: Prusament ASA printing
I am using a brand new stock Prusa Mini+. I am using PrusaSlicer 2.4.0 and the default PrusaSlicer settings for Prusament ASA. It is a fresh role of ASA straight out of the vacuum packed bag so I don't think it has absorbed any moisture. My DIY enclosure is running at 36C. Printing at .15 Quality, 260C nozzle and 100C bed, fan speed 20% and all the rest of the stock PrusaSlicer settings for ASA. Does anyone have any thoughts on where to start to try and clean up the pitting/voids on my prints?
Joel
I have found that ASA needs drying to get decent results, even right out of the package. I always dry my filament in a dehydrator and the results are always better. I can see quality degradation after as little as one day after drying, especially with ASA.
Regards,
Mark