Notifications
Clear all
First layer issue using various types of PLA
I'm seeing the rippling shown in the photo when printing the first layer. Does anyone have any suggestions as to what I'm doing wrong, or what's happening.
Thanks. 😀
Best Answer by FoxRun3D:
Ripples usually mean, the nozzle is too close to the printbed
This topic was modified 2 years temu 2 times by Idirian
Opublikowany : 14/05/2023 12:42 pm
RE: First layer issue using various types of PLA
Ripples usually mean, the nozzle is too close to the printbed
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
Opublikowany : 14/05/2023 3:33 pm
Idirian polubić
Topic starter
answered:
RE: First layer issue using various types of PLA
Riiiight. Thank you. 😀
Opublikowany : 14/05/2023 5:54 pm