Benachrichtigungen
Alles löschen
First layer issue using various types of PLA
I'm seeing the rippling shown in the photo when printing the first layer. Does anyone have any suggestions as to what I'm doing wrong, or what's happening.
Thanks. 😀
Best Answer by FoxRun3D:
Ripples usually mean, the nozzle is too close to the printbed
Dieses Thema wurde geändert Vor 2 years 2 mal von Idirian
Veröffentlicht : 14/05/2023 12:42 pm
RE: First layer issue using various types of PLA
Ripples usually mean, the nozzle is too close to the printbed
Formerly known on this forum as @fuchsr -- until all hell broke loose with the forum software...
Veröffentlicht : 14/05/2023 3:33 pm
Idirian gefällt das
Themenstarter answered:
RE: First layer issue using various types of PLA
Riiiight. Thank you. 😀
Veröffentlicht : 14/05/2023 5:54 pm