Notifiche
Cancella tutti
First layer issue using various types of PLA
I'm seeing the rippling shown in the photo when printing the first layer. Does anyone have any suggestions as to what I'm doing wrong, or what's happening.
Thanks. 😀
Best Answer by FoxRun3D:
Ripples usually mean, the nozzle is too close to the printbed
Questa discussione è stata modificata 2 years fa 2 tempo da Idirian
Postato : 14/05/2023 12:42 pm
RE: First layer issue using various types of PLA
Ripples usually mean, the nozzle is too close to the printbed
Formerly known on this forum as @fuchsr -- https://foxrun3d.com/
Postato : 14/05/2023 3:33 pm
Idirian hanno apprezzato
Topic starter
answered:
RE: First layer issue using various types of PLA
Riiiight. Thank you. 😀
Postato : 14/05/2023 5:54 pm