MAXTEMP Error
I've gotten past the testing/calibration phase, and tried to create a first print, but had an issue with extruding. After some troubleshooting, I'm stuck with the below error screen. When I hit reset, it reboots and displays the same screen, even after leaving it off for about 30 minutes.
I'm confused by the message, especially the 0/0.
Thoughts?
RE: MAXTEMP Error
Connector issue or not plugged properly ?
RE: MAXTEMP Error
I've gotten past the testing/calibration phase, and tried to create a first print, but had an issue with extruding. After some troubleshooting, I'm stuck with the below error screen. When I hit reset, it reboots and displays the same screen, even after leaving it off for about 30 minutes.
I'm confused by the message, especially the 0/0.
Thoughts?
Maybe the Thermistor is not connected, a broken wire or short circuit.
Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.