Notifications
Clear all

MAXTEMP Error  

  RSS
geofflloyd421
(@geofflloyd421)
New Member
MAXTEMP Error

I've gotten past the testing/calibration phase, and tried to create a first print, but had an issue with extruding. After some troubleshooting, I'm stuck with the below error screen. When I hit reset, it reboots and displays the same screen, even after leaving it off for about 30 minutes.

I'm confused by the message, especially the 0/0.

Thoughts?

 

Napsal : 12/05/2020 8:13 pm
John Doe
(@john-doe-3)
Estimable Member
RE: MAXTEMP Error

Connector issue  or not plugged properly ?

Napsal : 13/05/2020 7:12 am
karl-herbert
(@karl-herbert)
Illustrious Member
RE: MAXTEMP Error
Posted by: @geofflloyd421

I've gotten past the testing/calibration phase, and tried to create a first print, but had an issue with extruding. After some troubleshooting, I'm stuck with the below error screen. When I hit reset, it reboots and displays the same screen, even after leaving it off for about 30 minutes.

I'm confused by the message, especially the 0/0.

Thoughts?

 

 

Maybe the Thermistor is not connected, a broken wire or short circuit.

Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.

Napsal : 13/05/2020 9:13 pm
Share: