Hotend heater cartridge - thermal paste – Hardware, firmware and software help

Vookimedlo

(@vookimedlo)

Active Member

Hotend heater cartridge - thermal paste

Hello,

I'd like to ask you if I am supposed to use the thermal paste while inserting the hotend heater cartridge into the hotend heaterblock?

Thanks,

Michal

Best Answer by JoanTabb:

Processor thermal paste will go like concrete in the heat block

Slice engineering offer Boron Nitride Paste https://www.sliceengineering.com/products/boron-nitride-paste Its expensive and I have never used it.

I have used Copaslip antisieze on the nozzle threads (I always catch the first extrusion after changing the nozzles, in a tissue so that the coppaslip does not get on the build plate,
I expect you could use copaslip on the heater cartridge and thermistor cartridge
again, heat the hot end over a tissue pad, to ensure that nothing drips on the build plate

MOLYSLIP - COPASLIP | High Temperature Copper Anti-Seize Grease | Withstands Extreme Temperature (Up To 1100°C) | Protects Against Galling, Seizure Rust and Corrosion

available on Amazon, and in car spares shops

regards J0an

Postato : 16/12/2022 11:17 am

mark

(@mark)

Reputable Member

RE: Hotend heater cartridge - thermal paste

Posted by: @vookimedlo

Hello,

I'd like to ask you if I am supposed to use the thermal paste while inserting the hotend heater cartridge into the hotend heaterblock?

Thanks,

Michal

You should follow all these instructions precisely or results will not be satisfactory:

https://help.prusa3d.com/guide/how-to-replace-a-heaterblock-heatbreak-mini-mini_122769

It includes the thermal paste usage instructions as well as the dimensions and torque specs that should be used while assembling.

Regards,

Mark

Postato : 16/12/2022 12:24 pm

JoanTabb

(@joantabb)

Veteran Member Moderator