Flexible filament failed to print

Dernier message

RSS

b.ilya

(@b-ilya)

New Member

Flexible filament failed to print

I am using Ninjaflex on MINI+, prints were fine, every other material printed excellent (PLA, ASA, Nilon, Flex), in the last couple of tries the extruder failed to push the Ninjaflex filament. The filament is getting pushed out between the bowden tube and the filament spur. That problem never happened before and i can't solve it.

I Checked for clogging, tried different materials - prints were good.

DID A COLD PULL

Cleaned the spur gear.

*My observation: The problem is getting worse, at first the problem started after 3 layers, now its happening at purging

Publié : 15/03/2022 9:17 pm

Statistiques du forum

566 Forums

63.2 K Sujets

444.3 K Messages

19 En-ligne

68.1 K Membres

Le dernier des messages: First layer of some objects *sometimes* gets 'engraved' into the smooth PEI Sheet (PLA) Notre nouveau membre: etiennep Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé