Avisos
Vaciar todo
Firmware modification to add a thermocouple instead of thermistor
Hi everybody, I have an issue with the buddy board.
I have to put thermocouple instead of thermistor (thinner and more flexible for my needs).
I've been modified the firmware code about the sensor ( -4 : thermocouple with AD8495 signal amplificator), but after the wiring has been done, the screen show me 156°C, and i would like put the real temperature...
I guess this is due to the resistor or wrong code line in my firmware (resistor / displayed temperature).
If someone can point me in the right way because of I am struggling and the firmware of prusa is very complicated to compilate compared to mk3s firmware (.bbf, python ...)
Thanks a lots
Maxime
PS: below, the explanatory pictures
Respondido : 19/04/2023 9:21 am
RE: Firmware modification to add a thermocouple instead of thermistor
Have you tried putting the thermocouple in rice? 🙂
Respondido : 19/04/2023 3:48 pm
Deathaite me gusta