Can't load filament

Dernier message

RSS

mr printsley

(@mr-printsley)

New Member

Can't load filament

Hi,

Can't get the extruder to grab the filament. I can push it all the way down the tube into the extruder, but when I hit load, it never grabs. Before I unloaded the last filament, it was printing fine however.

Thanks for any help.

Publié : 09/05/2020 7:02 pm

tammets

(@tammets)

Active Member

RE: Can't load filament

https://help.prusa3d.com/en/article/clicking-extruder-under-extrusion-and-clogging-mini_112011#there-are-3-main-things-to-check-in-case-of-the-extruder-clicking-or-under-extrusion-on-the-mini

Check the tension of the idler on the springed-screw.

Publié : 13/05/2020 9:31 am

Matteo Cristini a aimé

Matteo Cristin...

(@matteo-cristini)

Reputable Member

RE: Can't load filament

Posted by: @priit-t

https://help.prusa3d.com/en/article/clicking-extruder-under-extrusion-and-clogging-mini_112011#there-are-3-main-things-to-check-in-case-of-the-extruder-clicking-or-under-extrusion-on-the-mini

Check the tension of the idler on the springed-screw.

I second this. I had a similar issue and adjusting the idler tension fixed it.

Publié : 18/05/2020 2:33 pm

Statistiques du forum

565 Forums

63.6 K Sujets

446 K Messages

25 En-ligne

68.9 K Membres

Le dernier des messages: Déformation pièce/problème filetage Notre nouveau membre: Kiley Murphy Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé