Notifications
Clear all

PLEASE HELP JUST WONT PRINT WELL!  

Page 2 / 2
  RSS
Diem
 Diem
(@diem)
Famed Member

Your first layer calibration is going up and down like a yoyo - the most recent one (4:55 pm) is too low.

Cheerio,

Posted : 30/01/2022 7:04 pm
JoanTabb
(@joantabb)
Moderator
RE: PLEASE HELP JUST WONT PRINT WELL!

the chat option in the Prusa eShop, is usually the quickest way to resolve problems.

you can give them a link to this page so that they can see the issues

regards Joan

I try to make safe suggestions,You should understand the context and ensure you are happy that they are safe before attempting to apply my suggestions, what you do, is YOUR responsibility. Location Halifax UK

Posted : 30/01/2022 11:20 pm
Shoutbanger
(@shoutbanger)
Active Member
Topic starter answered:
RE: PLEASE HELP JUST WONT PRINT WELL!

That's exactly what we thought. Thing is we only move it one increment at a time as per instructions.

Posted : 31/01/2022 12:04 pm
Shoutbanger
(@shoutbanger)
Active Member
Topic starter answered:
RE: PLEASE HELP JUST WONT PRINT WELL!

Thanks Joan

I will be in touch with customer service tomorrow.

Posted : 31/01/2022 12:05 pm
Sp4rkR4t
(@sp4rkr4t)
Estimable Member
RE: PLEASE HELP JUST WONT PRINT WELL!

 

Posted by: @shoutbanger

Yes 210C. (Typo)

That's another thing I noted. My mini plus reverts to 170C every time I try to print. I have to manually adjust it in the 'tune' section. I have set it to 210C in the settings but for some reason it reverts back to 170C. 

The 170 temp at the start of the print is only for the bed levelling procedure, it will then warm up to the correct temp as set in the gcode file.

Posted : 31/01/2022 12:09 pm
MysDawg liked
Page 2 / 2
Share: