Notifications
Clear all
filament sensor values and calibration
Just upgraded to MK3.9 and other than filament sensor, self test is OK. It seems like filament sensor does not detect anything, and when I look at the values, with no filament it is like 1'030'000, and when I insert filament 1'040'000. I read a few posts, it should be a very low value for no filament. Is that the expected behavior ? Very low <100K values for no filament and >1M values for filament inserted ? Regarding to my case, what can be the problem then ?
Publié : 29/09/2023 10:08 am
Topic starter
answered:
RE: filament sensor values and calibration
I realized I put the part with spring, magnet, ball reverse. Then, I think the hall sensor was either too far or too close to the magnet and always showing ~1M. I fixed that, and now I see <~500K without filament, and >~1.5M with filament.
Publié : 29/09/2023 1:06 pm