Benachrichtigungen
Alles löschen
Seite 2 / 2
Vorherige
RE: Filament changing bug?
This is extremely frustrating - ok I get it I probably have some issue with my sensor that needs fixing - but to not have an override on this is just poor design.
The machine thinks it has filament stuck in it, but it doesn't. But I can't finish a filament change because of this and it results in having to throw out my whole print.
I'll try the power plug hack but please Prusa add a manual override!
Veröffentlicht : 08/10/2024 1:53 am
RE: Filament changing bug?
HELP
is this the same
I have a mk3s and a new MK4 and my issue is that each time I go to print a new SLT after the calibration and after the pre line in the top left is done. the printer slides over and stops and asks for a filament change after I unload and reload it prints the entire job without a hitch. this happens each and every time.
Veröffentlicht : 25/10/2024 9:52 pm
Seite 2 / 2
Vorherige