Benachrichtigungen
Alles löschen
Bed Leveling Failed - off by miles!
Recently I have bed leveling failed error a when I watch it’s off by miles. The printer does nozzle clean fine, then it goes to level and for a few spots it’s OK then suddenly off and steps farther away. At the same time my printer started sounding like a freight train from the printer hot end fan. If I tap my finger on the fan I can feel it’s vibrating like nuts. Are they related I don’t know?
load cell test passes during calibration.
z axis calibration passes. Heck I’ll save some trouble the whole printer passes calibration test.
I cannot find anywhere a Prusa article on MK4 bed leveling failed.
got any ideas?
Veröffentlicht : 19/05/2024 10:18 pm
Themenstarter answered:
RE: Bed Leveling Failed - off by miles!
The issue was a dying print fan.
Veröffentlicht : 14/07/2024 10:13 pm
ssmith gefällt das