Benachrichtigungen
Alles löschen
Bad quality prints
I’m not sure what’s happening here with MK4 input shaping enabled. I’m getting these lines on PLA filament using generic PLA profile.
MK4 firmware 5.1.0
Prusaslicer2.7
nozzle 0.4
Please help
Veröffentlicht : 10/12/2023 12:57 pm
RE: Bad quality prints
Is this a factory or kit assembled unit?
Veröffentlicht : 10/12/2023 1:16 pm
Themenstarter answered:
RE: Bad quality prints
upgraded from MK3s
Veröffentlicht : 10/12/2023 1:21 pm
RE: Bad quality prints
I’m sorry, this is out of my experience zone then, I’m a kit builder. My next check was to make sure your z axis is all correctly assembled, followed by y axis.
Are the lines oriented with the x axis travel or the y axis travel?
Veröffentlicht : 10/12/2023 1:44 pm