Notifications
Clear all

Control knob  

  RSS
michael.p12
(@michael-p12)
Active Member
Control knob

Hello all the control part on the LCD board.is it possible to get the part.and solder a new one on.it has stopped clicking.

Thanks

 

 

Posted : 30/05/2021 9:07 am
cwbullet
(@cwbullet)
Member
RE: Control knob
Posted by: @michael-p12

Hello all the control part on the LCD board.is it possible to get the part.and solder a new one on.it has stopped clicking.

Thanks

Anything is possible, but I would not recommend it.  Unless you are experienced with soldering electronics boards, you could easily damage the LCD board.  

--------------------
Chuck H
3D Printer Review Blog

Posted : 30/05/2021 10:21 am
RedDawg
(@reddawg)
Reputable Member
RE: Control knob

By "stopped clicking" do you mean that it no longer has the tactile "feel" of clicking or that it no longer performs its electrical function? And is this for the rotational counting of pulses (selecting) or the "push" function (activation of the selection)? Both? If your unit is still under warranty, I expect support will send you a new control board. If not under warranty, buy a new one, plug and play.

Hear ye, Hear ye! Step right up folks and get your Government salvation here! Less than $.002 per word! Amazon.com/dp/B0B8XMMFP4

Posted : 30/05/2021 11:05 am
Share: