Covid headband seam issue
 
Notifiche
Cancella tutti

Covid headband seam issue  

  RSS
Johno
(@johno-2)
New Member
Covid headband seam issue

Hello , I am printing headbands for shields quadro and double, using Simplify 3D, but after slicing and printing , there is a seam in the middle of the part which is touching forehead. This is appearing only in the middle, like there would be a tube modeled inside if the middle part. Any idea how to avoid this?

Yes I know it is not appearing if I use other slicer, but there has to be something which could help in Simplify as well.

 Thanks for your advice.

Jan

Postato : 21/04/2020 9:08 am
karl-herbert
(@karl-herbert)
Illustrious Member
RE: Covid headband seam issue
Posted by: @hdolezel

Hello , I am printing headbands for shields quadro and double, using Simplify 3D, but after slicing and printing , there is a seam in the middle of the part which is touching forehead. This is appearing only in the middle, like there would be a tube modeled inside if the middle part. Any idea how to avoid this?

Yes I know it is not appearing if I use other slicer, but there has to be something which could help in Simplify as well.

 Thanks for your advice.

Jan

In PS the seampositions you can modify here:

with aligned you usually get good results.

S3D look here: https://forum.simplify3d.com/download/file.php?id=1057&mode=view

Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.

Postato : 21/04/2020 10:08 am
Johno
(@johno-2)
New Member
Topic starter answered:
RE: Covid headband seam issue

@karl-herbert

Thank you for your reply, but I think that is not the issue. I have found, that there is something like small tube modeled inside the stacked Covid headbands, PS is taking that as a one solid bit, but S3D is finding the tube and slicing that as well. 

And that is causing the seam exactly in the middle of the headband.

 

 

Questo post è stato modificato 4 years fa da Johno
Postato : 22/04/2020 12:50 pm
Condividi: