Powering the Buddy3D on a Core One
Hello,
I've recently purchased the Buddy3D camera for the Core One. After it arrived I quickly checked its functionality, connected it and went on to install it following the installation guide. When I turned the printer on, sadly the camera didn't work. First I thougt I had damaged the cable. But after some testing it turns out that the upper USB-C-Port (as specifically mentioned in the installation guide) on my Core One doesn't seem to provide any power.
Has anyone encountered this issue before?
Best Answer by k1mu:
There's a menu setting to enable/disable the camera. If that's turned off, then there's no power on that upper jack.
RE: Powering the Buddy3D on a Core One
There's a menu setting to enable/disable the camera. If that's turned off, then there's no power on that upper jack.
RE: Powering the Buddy3D on a Core One
Thank you very much!! That fixed it.
I just checked the installation guide and it is absolutely mentioned at step 20. And I was sure I had read it thoroughly...