Mitigate Spool From Being Tugged Along Spool Holder
Hello,
I have the prusa enclosure setup as per the instructions ( https://help.prusa3d.com/guide/4c-installing-the-printer-mk4-mk3-9_477487#479181). I've noticed that during prints the spool will be tugged along the spool holder until it bumps up against the rim of the spool holder.
Is there anyway to mitigate this issue while leaving the spool inside the enclosure, and not mounting it ontop of the enclosure or on the side? Apologies if this has been asked already but I haven't been able to find any information relating to this.
RE: Mitigate Spool From Being Tugged Along Spool Holder
Why is that a problem? 😉
RE: Mitigate Spool From Being Tugged Along Spool Holder
I'm not sure if it's a problem persay, but would be nice to eliminate the nose it makes when it shuffles along the spool holder. However wouldn't it cause extra vibrations when printing that could potentially effect print quality?