Mitigate Spool From Being Tugged Along Spool Holder
 
Notifications
Clear all

Mitigate Spool From Being Tugged Along Spool Holder  

  RSS
bonedaddy
(@bonedaddy)
Member
Mitigate Spool From Being Tugged Along Spool Holder

Hello,

I have the prusa enclosure setup as per the instructions ( https://help.prusa3d.com/guide/4c-installing-the-printer-mk4-mk3-9_477487#479181). I've noticed that during prints the spool will be tugged along the spool holder until it bumps up against the rim of the spool holder.

Is there anyway to mitigate this issue while leaving the spool inside the enclosure, and not mounting it ontop of the enclosure or on the side? Apologies if this has been asked already but I haven't been able to find any information relating to this.

Posted : 02/06/2024 8:21 am
ventrue3000
(@ventrue3000)
Active Member
RE: Mitigate Spool From Being Tugged Along Spool Holder

Why is that a problem? 😉

Posted : 02/06/2024 1:18 pm
ChiefSmeg liked
bonedaddy
(@bonedaddy)
Member
Topic starter answered:
RE: Mitigate Spool From Being Tugged Along Spool Holder

I'm not sure if it's a problem persay, but would be nice to eliminate the nose it makes when it shuffles along the spool holder. However wouldn't it cause extra vibrations when printing that could potentially effect print quality?

Posted : 03/06/2024 1:07 am
Share: