Z leveling enforced

Dernier message

RSS

BillberryC

(@billberryc)

New Member

Z leveling enforced

Hi, finished assembly of my MK3S a week ago and did several prints using PLA and PETG working good. But since yesterday evening I always get a Z leveling enforced error (front right point - number 7). performed again the preflight check, Pinda ajustment and selftest but the problem remains the same if I start to print ... Please provider me some hints what I can do.

Thank you very much

Gerhard

Publié : 16/06/2020 8:02 am

Gordon W

(@gordon-w)

Reputable Member

RE: Z leveling enforced

Gerhard,

You have posted this in the section for the Mini, although you will find some people who have both machines and can help you, you will probably get a better response if you post in the Mk3 section.

Good luck finding a fix for the problem.

Gordon

Publié : 16/06/2020 9:08 am

Neophyl

(@neophyl)

Illustrious Member

RE: Z leveling enforced

https://forum.prusa3d.com/forum/original-prusa-i3-mk3s-mk3-hardware-firmware-and-software-help/unable-to-calibrate-after-error-z-levelling-enforced/#post-152964

Publié : 16/06/2020 9:39 am

Statistiques du forum

559 Forums

62.8 K Sujets

442.4 K Messages

20 En-ligne

67.4 K Membres

Le dernier des messages: Pla prints with large supported area has Bad surface finish Notre nouveau membre: pinklemonade Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé