Visible lines on surfaces and first layer distorsions
 
Notifications
Clear all

Visible lines on surfaces and first layer distorsions  

  RSS
DrorFux
(@drorfux)
Active Member
Visible lines on surfaces and first layer distorsions

Hey all,

I don't actually know how to explain this, but I think you can see the problem in the images below. First, the first layer always looks the worst, I don't know if it's happening because the nozzle is too low (-0.4). I think also stringing appears sometimes.

It all began few weeks ago. I don't think my filament got a lot of humidity because I keep it in a closed bag with Silica Gel pad.

Thanks in advance for the help!

Dror

Here you can see the filament looks "rough" with a bad surface finish.

Posted : 09/01/2021 12:01 pm
Share: