Suddenly unnable to complete first layer - can't print
Hello all,
All of a sudden my prusa mini plus has issues with printing.
It starts fine but after 5 - 15 minutes it stops extruding.
I tried two different filaments of EU origin and the result is the same.
I dissasembled the extruder but there was nothing special to be find to help with this issue.
Any advice is appriciated.
HeatCreep ?
BR,
Vedran
RE: Suddenly unnable to complete first layer - can't print
@avedran I don't know much, but when I had a similar problem, it was because my Minda sensor wire was getting "worn". Once I was on chat with support, they had me wiggle the wires while watching the red light on the Minda. It did not stay on steady, so they sent me a new one. You might already have the Super Pinda, and I think the cabling is better on that one so this is less likely to be a problem. Still, you could test it the same way.
Good luck finding the cause.