Notifications
Clear all

Probe never low enough  

  RSS
TheJoyOfPrinting
(@thejoyofprinting)
Eminent Member
Probe never low enough

Had an issue and the printer said it had not been calibrated. I did the calibration again and it always grabs the paper no matter how low I put the probe. I followed that the instructions said to do with the zip tie and even put it closer than that but it always grabs the paper. Any thoughts to what I’m missing? 

Posted : 30/09/2020 12:11 am
cwbullet
(@cwbullet)
RE: Probe never low enough

Contact support by chat.  You may have a bad probe.  

--------------------
Chuck H
3D Printer Review Blog

Posted : 30/09/2020 12:17 am
karl-herbert
(@karl-herbert)
Illustrious Member
RE: Probe never low enough
Posted by: @jhopke

Had an issue and the printer said it had not been calibrated. I did the calibration again and it always grabs the paper no matter how low I put the probe. I followed that the instructions said to do with the zip tie and even put it closer than that but it always grabs the paper. Any thoughts to what I’m missing? 

A red LED should normally light up on the sensor. As soon as you drive with a metallic object near the sensor head, it should go out. If it doesn't or if the LED doesn't shine at all, I would, as charles already mentioned, contact the Prusachat.

Statt zu klagen, dass wir nicht alles haben, was wir wollen, sollten wir lieber dankbar sein, dass wir nicht alles bekommen, was wir verdienen.

Posted : 30/09/2020 7:39 am
Share: