Notifications
Clear all
Newbie question: How to avoid 3D print artifacts?
I am a complete newbie and just try switching the original Prusa filament with a third party one.
Tried with the temperature settings 215/60 (Hot end/Heated Bed) degrees Celsius but it did not go well. I changed the settings to 200/50 and the final result has many artifacts. I am pretty sure that the Z axis was OK while checking the first layers. How could I avoid these/particles? What could cause them?!?
Opublikowany : 13/09/2020 3:07 pm
RE: Newbie question: How to avoid 3D print artifacts?
Have you done any calibration prints such as the temperature tower?
--------------------
Chuck H
3D Printer Review Blog
Opublikowany : 26/09/2020 10:51 am