Notifications
Clear all
Heatbed is shaking when it moves forward but only on diagonals.
Two sides (facing right front and right rear corners) came out with waves. Is it expected or my printer needs an alignment? This is a new MINI+ purchased as semi-assembled. I can see the heatbed shaking when these 2 sides are printed. it happens only on diagonals and when the heatbed moves forward.
Best Answer by max:
Upon additional investigation I found that Y axis belt was not tensioned at all.
Posted : 22/01/2022 7:05 am
Topic starter
answered:
RE: Heatbed is shaking when it moves forward but only on diagonals.
Upon additional investigation I found that Y axis belt was not tensioned at all.
Posted : 22/01/2022 6:28 pm